Removing 4Wd Clutch - wsm M6040 Workshop Manual

M6040, M7040, WSM

(3) Removing 4WD Clutch

4WD Clutch
1. Remove the 4WD clutch (1).
(When reassembling)
• Replace the seal rings (2) with new one.
• Apply grease to the seal rings (2) when assembling.
(1) 4WD Clutch
Clutch Holder
1. Remove the hydraulic pipes (1) and (2).
2. Pull out the pipes (4) using the M6 × P1.0 screw (6) as shown
photo.
3. Remove the clutch holder (6).
(When reassembling)
• Apply oil to the O-rings (3).
Joint screw for hydraulic
Tightening torque
pipe
(1) Hydraulic Pipe (2WD)
(2) Hydraulic Pipe (4WD)
(3) O-ring
3-S42
TRANSMISSION
(2) Seal Ring
9Y1210143TRS0071US0
29.4 to 34.3 N·m
3.0 to 3.5 kgf·m
21.7 to 25.3 lbf·ft
(4) Pipe
(5) M6 × P1.0 Screw
(6) Clutch Holder
9Y1210143TRS0072US0
KiSC issued 07, 2012 A