Preparation For Separating Each Block; Lubricant And Coolant; 4Wd Propeller Shaft And Power Steering Hose - wsm M6040 Workshop Manual

M6040, M7040, WSM

[2] PREPARATION FOR SEPARATING EACH BLOCK

(1) Lubricant and Coolant

(2) 4WD Propeller Shaft and Power Steering Hose

Draining Transmission Fluid and Fuel
1. See page G-10 and G-21.
Propeller Shaft
1. Slide the propeller shaft cover (3) after removing the screw (8).
2. Tap out the roll pins (2) and then slide the coupling (1) to the
rear.
(When reassembling)
• Apply grease to the splines of the propeller shaft (5) and pinion
shaft.
• Tap in the roll pins (2) as shown in figure.
(1) Coupling
(2) Roll Pin
(3) Propeller Shaft Cover
(4) Roll Pin
Power Steering Hose
1. Disconnect both power steering hoses (2) from power steering
cylinder (1).
(When reassembling)
• Connect the power steering hose with ID tape (3) to the R.H..
Power steering hose
Tightening torque
retaining nut
(1) Power Steering Cylinder
(2) Power Steering Hose
3-S17
TRANSMISSION
9Y1210143TRS0011US0
(5) Propeller Shaft
(6) Cover
(7) Coupling
(8) Screw
9Y1210143ENS0028US0
22.6 to 27.5 N·m
2.3 to 2.8 kgf·m
16.6 to 20.3 lbf·ft
(3) ID Tape
9Y1210143ENS0029US0
KiSC issued 07, 2012 A