Main Switch (Cabin Model) - wsm M6040 Workshop Manual

M6040, M7040, WSM

(2) Main Switch (CABIN Model)

Main Switch at START Position
1. Turn and hold the main switch at the START position.
2. Measure the resistances with an ohmmeter across the terminal
B and the terminal ST and across terminal B and the terminal M.
3. If 0 ohm is not indicated, these contacts of the main switch are
faulty.
Terminal B – Terminal ST
Resistance
Terminal B – Terminal M
Main Switch
1. Remove the panel cover (1).
2. Remove the air outlet (3) and (4).
3. Remove the panel under cover R.H. (5) and disconnect the
connector.
4. Perform the following checking.
(1) Panel Cover
(2) Main Switch
(3) Air Outlet
Connector Voltage
1. Measure the voltage with a voltmeter across the connector
terminal 3 and chassis.
2. If the voltage differs from the battery voltage, the wiring harness
is faulty.
Connector terminal 3 –
Voltage
Chassis
(1) Main Switch
9-S15
ELECTRICAL SYSTEM
0 Ω
0 Ω
9Y1210143ELS0018US0
(4) Air Outlet
(5) Panel Under Cover R.H.
(6) Connector
9Y1210143ELS0019US0
Approx. battery voltage
(2) Main Switch Connector
(Wire Harness Side)
9Y1210143ELS0020US0
KiSC issued 07, 2012 A