wsm M6040 Workshop Manual page 41

M6040, M7040, WSM
Replacing Hydraulic Oil FIlter
CAUTION
• Allow engine to cool down sufficiently, oil can be hot and
can burn.
1. Remove the drain plug (1) at the bottom of the transmission
case and drain the oil completely into the oil pan.
2. After draining reinstall the drain plug (1).
3. Remove the two oil filters (2).
4. Wipe off metal fillings with clean rags at the magnetic filters (3).
5. Put a film of clean transmission fluid on rubber seal of new
filters.
6. Tighten the filter quickly until it contacts the mounting surface.
Tighten filter by hand and additional 1/2 turn only.
7. After the new filter has been replaced, fill with the oil up to the
upper notch on the dipstick (4).
8. After running the engine for a few minutes, stop it and check the
oil level again, add oil to the prescribed level.
9. Make sure that the transmission fluid doesn't leak through the
seal.
IMPORTANT
• To prevent serious damage to the hydraulic system, use
only a KUBOTA genuine filter.
(1) Drain Plug
(2) Hydraulic Oil Filter
(3) Magnetic Filter (Clean off Metal
Fillings)
(4) Dipstick
(5) Oil Filling Plug
G-20
GENERAL
(A) Oil level is acceptable within this
range.
9Y1210143GEG0012US0
KiSC issued 07, 2012 A