wsm M6040 Workshop Manual page 503

M6040, M7040, WSM
2) 4WD Switch
1. Check the continuity through switch with an ohmmeter.
2. If continuity specified below are not indicated, the switch is
faulty.
(1) 4WD Switch
(2) 4WD Switch Connector
(Switch Side)
(3) 4WD / Bi-speed Turn Switch
Connector (Wiring Harness Side)
4WD Switch (CABIN Model)
1) Connector Voltage
1. Turn the main switch to ON position.
2. Measure the voltage with a voltmeter across the terminal b and
chassis.
3. If the voltage differ from the battery voltage, the wiring harness
or fuse is faulty.
NOTE
• The terminal b of 3P connector for 4WD switch is red/green
color wire.
Voltage Terminal b – Chassis
(1) 4WD Switch
2) 4WD Switch
1. Test the continuity through the switch with an ohmmeter.
2. If continuity specified below is not indicated, the switch is faulty.
(1) 4WD Switch
9-S34
ELECTRICAL SYSTEM
(4) Terminal W/L for Illumination
(5) Terminal W/L for 4WD
9Y1210143ELS0053US0
Approx. battery voltage
(2) 3P Connector (Wire Harness Side)
9Y1210143ELS0054US0
9Y1210143ELS0055US0
KiSC issued 07, 2012 A