M6040, M7040, WSM
Preparation 1
1. Open the bonnet (2) and disconnect the battery (3) negative
terminal and 6P connector (5) for head light.
2. Remove the bonnet dampers (6) and bonnet (2).
3. Remove the both side covers (4).
4. Remove the muffler pipe (1) mounting screws and remove the
muffler pipe (1).
5. Install the front axle rocking restrictor (12) to the front axle
bracket.
6. Remove the muffler pipe (13).
IMPORTANT
• When disconnecting the battery cables, disconnect the
grounding cable first. When connecting, positive cable
first.
(When reassembling)
• Connect the engine harness (9) connector and head light
harness (7) connector within the space of controller pipe (8),
heater hose (10) and delivery hose (11) as shown photo.
(1) Muffler Pipe
(2) Bonnet
(3) Battery
(4) Side Cover
(5) 6P Connector (Head Light)
(6) Damper
(7) Wire Harness (Head Light)
10-S34
(8) Controller Pipe
(9) Wire Harness (Engine)
(10) Heater Hose
(11) Delivery Hose
(12) Rocking Restrictor
(13) Muffler Pipe
9Y1210143CAS0060US0
KiSC issued 07, 2012 A
CABIN