Servicing; Lift Arm And Top Link Bracket - wsm M6040 Workshop Manual

M6040, M7040, WSM

6. SERVICING

[1] LIFT ARM AND TOP LINK BRACKET

Lift Arm Support Bushing
1. Visually inspect the DX bushings for signs of wear or damage.
(The DX bushing tends to show concentrated wear.)
2. If the DX bushing is worn beyond the alloy portion "A", replace
it.
(When installing)
• When press-fitting a new bushing with a press-fitting tool (see
page G-71) and observe the dimensions described in the figure.
• When press-fitting a new bushing, apply transmission fluid to
the lift arm support liner boss.
• When press-fitting a new bushing
– Lift arm support bushing's seam face to rear and hole face
to front and upper.
– Lift arm bushing's seam face to front and lower and hole
face to rear.
Press-fit location of
Factory specification
bushing "L1"
(Reference)
Lift arm support and lift
Alloy thickness "A"
arm bushing
(1) Lift Arm Support Bushing
(2) Lift Arm Bushing
8-S32
HYDRAULIC SYSTEM
11.0 mm
0.433 in.
0.57 mm
0.0224 in.
A: Alloy Thickness
L: Press-fit Location
9Y1210143HYS0039US0
KiSC issued 07, 2012 A