wsm M6040 Workshop Manual page 75

M6040, M7040, WSM
Jig for Governor Connecting Rod
Application
• Use for connecting the governor connecting rod to the rack pin of the fuel injection pump assembly.
NOTE
• The following special tools are not provided, so make them referring to the figure.
A 0.5 mm (0.0197 in.)
B 12.7 to 13.0 mm (0.5000 to 0.5118 in.)
C 8.7 to 9.0 mm (0.3425 to 0.3543 in.)
D 39 mm (1.5354 in.)
E 10 mm (0.3937 in.)
F 7 mm (0.2756 in.)
G 6 mm (0.2362 in.)
H 80 mm (3.1496 in.)
I 27.95 to 28.05 mm (1.1004 to 1.1043 in.)
J 5 mm (0.1969 in.)
3.00 to 3.01 mm dia., 6 mm depth
K
(0.1181 to 0.1185 in.dia., 0.2362 in. depth)
L 9 mm (0.3543 in.)
M 5 mm (0.1969 in.)
N 14.45 to 14.55 mm (0.5689 to 0.5728 in.)
(1) Material: S43C-D (2) Permanent Magnet:
8 mm dia. (0.3150 in. dia.)
Thickness: 3 mm (0.1181 in.)
O 5 mm (0.1969 in.)
P 4 mm (0.1575 in.)
Q 2.955 to 2.965 mm dia. (0.1163 to 0.1167 in. dia.)
R 3.020 to 3.030 mm dia. (0.1189 to 0.1193 in. dia.)
S Ra = 1.6 a
AA Governor housing side
BB Press in side
a 0.6 mm radius (0.0236 in. radius)
b 1 mm radius (0.0394 in. radius)
C0.2 Chamfer 0.2 mm (0.0079 in.)
C0.4 Chamfer 0.4 mm (0.0157 in.)
C0.5 Chamfer 0.5 mm (0.0197 in.)
C1 Chamfer 1.0 mm (0.0394 in.)
C2 Chamfer 2.0 mm (0.0787 in.)
(3) Pin
G-54
GENERAL
9Y1210143GEG0086US0
KiSC issued 07, 2012 A