Piston And Connecting Rod - wsm M6040 Workshop Manual

M6040, M7040, WSM

(9) Piston and Connecting Rod

Oil Pan and Oil Strainer
1. Unscrew the oil pan mounting screws and remove the oil pan
(1).
2. Unscrew the oil strainer mounting screws (3), and remove the
oil strainer (4).
(When reassembling)
• Install the oil strainer, using care not to damage the O-ring (2).
• Apply liquid gasket (Three Bond 1217D) to the crankcase 2 as
shown in the figure.
• Confirm that the liquid gasket coating surface is free of water,
dust and oil in order to maintain sealing effect.
• Carefully apply the adhesive evenly.
NOTE
• When mounting the adhesive-applied parts, take care to fit
them to the mating parts.
• Assemble the adhesive-applied parts within ten minutes.
• To avoid uneven tightening, tighten mounting screws in
diagonal order from the center.
• After cleaning the oil strainer, install it.
• Attach the oil pan so that the drain plugs will approach the
flywheel housing side.
(1) Oil Pan
(2) O-ring
(3) OIl Strainer Mounting Screw
(4) Oil Strainer
(5) Liquid Gasket
Tappet
1. Remove the tappets (1) from the tappet bore of the crankcase 1
(3) using magnetic tool.
(When reassembling)
• Before installing the tappets (1), apply engine oil thinly around
them.
NOTE
• Mark the cylinder number to the tappets to prevent
interchanging.
(1) Tappet
(2) Tappet Bore
1-S56
ENGINE
(6) Crankcase 2
(7) Drain Plug
A: Flywheel Housing Side
B: Front Cover Side
9Y1210143ENS0080US0
(3) Crankcase 1
9Y1210143ENS0081US0
KiSC issued 07, 2012 A