wsm M6040 Workshop Manual page 82

M6040, M7040, WSM
Balancer Shaft 2 Bearing D Replacing Tool
Application
• Use to press fit the bearing.
NOTE
• The following special tools are not provided, so make them referring to the figure.
A 34.5 mm dia. (1.3583 in. dia.)
B 30.8 to 30.9 mm dia. (1.2126 to 1.2165 in.)
C 24 mm dia. (0.9449 in. dia.)
D 0.523 rad (30 °)
E 0.523 rad (30 °)
F 26 mm dia. (1.0236 in. dia.)
G 46 mm dia. (1.8110 in. dia.)
H 34.9 to 35.0 mm dia. (1.3740 to 1.3780 in. dia.)
4.000 to 4.018 mm dia., 7 mm depth
I
(0.1575 to 0.1582 in. dia., 0.2756 in. depth)
J 1.2 mm (0.0472 in.)
K 5 mm (0.1969 in.)
L 1.5 mm (0.0591 in.)
M 8 mm (0.3150 in.)
N 15 mm (0.5906 in.)
O 20 mm (0.7874 in.)
P 99 mm (3.8976 in.)
Q 29.5 mm (1.1614 in.)
R 24.5 mm (0.9646 in.)
S 424.5 to 425.5 mm (16.7126 to 16.7520 in.)
(1) Shaft (2) Stopper
T 120 mm (4.7244 in.)
U 479 mm (18.8583 in.)
V 1.605 rad (92 °)
W 35 mm dia. (1.3780 in. dia.)
X 9 mm (0.3543 in.)
Y 0.523 rad (30 °)
Z 84.5 to 85.5 mm (3.3268 to 3.3661 in.)
a 50 mm (1.9685 in.)
b 0.698 rad (40 °)
c 2 mm (0.0787 in.)
d 3 mm (0.1181 in.)
e 2 mm radius (0.0787 in. radius)
f Ra = 3.2 a
g 0.3 mm radius (0.0118 in. radius)
h 0.8 mm radius (0.0315 in. radius)
i 8.0 mm radius (0.3150 in. radius)
j 0.4 mm radius (0.0157 in. radius)
C0.5 Chamfer 0.5 mm (0.0197 in.)
C1 Chamfer 1.0 mm (0.0394 in.)
G-61
GENERAL
9Y1210143GEG0093US0
KiSC issued 07, 2012 A