Cabin Model - wsm M6040 Workshop Manual

M6040, M7040, WSM

(2) CABIN Model

Steering Controller
1. Disconnect the shuttle cable (7).
2. Disconnect the power steering delivery hose 1 (1) and hose 2
(3) from power steering controller.
3. Disconnect the oil cooler pipes (2) and (4).
4. Remove the steering controller mounting screws (5) and
steering controller (6).
(When reassembling)
• Be sure to assemble the power steering delivery hose to original
position.
• After assembling the power steering controller, be sure to adjust
the shuttle lever "Neutral" position.
Power steering delivery
hose retaining nut
Controller pipe retaining nut
Tightening torque
Oil cooler pipe retaining nut
Power steering controller
mounting screw
(1) Power Steering Delivery Hose 1
(2) Oil Cooler Pipe
(3) Power Steering Delivery Hose 2
(4) Oil Cooler Pipe
Bonnet
1. Open the bonnet (3) and disconnect the battery negative
terminal.
2. Disconnect the connector (2) for head lights.
3. Disconnect the dampers (1).
4. Remove the bonnet (3).
IMPORTANT
• When disconnecting the battery cables, disconnect the
grounding cable first. When connecting, positive cable
first.
(When reassembling)
• Connect the engine harness (6) connector and head light
harness (4) connector within the space of controller pipe (5),
heater hose (7) and delivery hose (8) as shown photo.
(1) Damper
(2) Connector
(3) Bonnet
(4) Wire Harness (Head Light)
7-S6
STEERING
22.6 to 27.5 N·m
2.3 to 2.8 kgf·m
16.6 to 20.3 lbf·ft
49.0 to 68.6 N·m
5.0 to 7.0 kgf·m
36.2 to 50.6 lbf·ft
49.0 to 68.6 N·m
5.0 to 7.0 kgf·m
36.2 to 50.6 lbf·ft
48.1 to 55.8 N·m
4.9 to 5.7 kgf·m
35.5 to 41.2 lbf·ft
(5) Screw
(6) Steering Controller
(7) Shuttle Cable
9Y1210143STS0008US0
(5) Controller Pipe
(6) Wire Harness (Engine)
(7) Heater Hose
(8) Delivery Hose
9Y1210143STS0009US0
KiSC issued 07, 2012 A