wsm M6040 Workshop Manual page 502

M6040, M7040, WSM
Engine Rotation Sensor and Travel Speed Sensor
1. Check the engine speed meter and travel speed display.
2. It is OK if engine speed is displayed in the meter panel.
3. It is OK if traveling speed is displayed in the LCD monitor.
NOTE
• As for engine speed sensor and travel speed sensor are not
checking with circuit tester.
(1) Engine Rotation Sensor
4WD Switch (ROPS Model)
1. Remove the 4WD switch (1).
1) Connector Voltage
1. Turn the main switch to ON position.
2. Measure the voltage with a voltmeter across the connector each
W/L terminal and chassis.
3. If the voltage differs from the battery voltage, the wiring harness
is faulty.
Voltage W/L terminal – Chassis
(1) 4WD Switch
(2) 4WD Switch Connector
(Switch Side)
(3) 4WD Switch Connector
(Wiring Harness Side)
9-S33
ELECTRICAL SYSTEM
(2) Travel Speed Sensor
9Y1210143ELS0051US0
Battery voltage
(11 to 14 V)
(4) Terminal W/L for Illumination
(5) Terminal W/L for 4WD
9Y1210143ELS0052US0
KiSC issued 07, 2012 A