wsm M6040 Workshop Manual page 201

M6040, M7040, WSM
Oil Clearance of Camshaft Journal
1. Measure the camshaft journal O.D. with an outside micrometer.
2. Measure the cylinder block bore I.D. for camshaft with an inside
micrometer.
3. If the clearance exceeds the allowable limit, replace the
camshaft.
Factory specification
Oil clearance of
camshaft journal
Allowable limit
Camshaft journal 1 O.D. Factory specification
Camshaft block bore 1
Factory specification
I.D.
Camshaft journal 2 O.D. Factory specification
Camshaft block bore 2
Factory specification
I.D.
(1) Camshaft Journal 1
Replacing Camshaft Cover (If necessary)
1. Remove the used camshaft cover and clean the hole.
2. Install the new camshaft cover (1) until bumping using camshaft
cover replacing tool. (See page G-45.)
(1) Camshaft Cover
Balancer Shaft Side Clearance
1. Set a dial indicator with tip on the balancer shaft.
2. Measure the side clearance by moving the balancer shaft to the
front and rear.
3. If the measurement exceeds the allowable limit, replace the
balancer shaft.
Factory specification
Side clearance of
balancer shaft 1
Allowable limit
Factory specification
Side clearance of
balancer shaft 2
Allowable limit
(A) Side Clearance of
Balancer Shaft 2
1-S69
ENGINE
0.050 to 0.091 mm
0.0020 to 0.0036 in.
0.15 mm
0.0059 in.
34.034 to 34.050 mm
1.3399 to 1.3406 in.
35.000 to 35.025 mm
1.3780 to 1.3789 in.
43.934 to 43.950 mm
1.7297 to 1.7303 in.
44.000 to 44.025 mm
1.7323 to 1.7333 in.
(2) Camshaft Journal 2
9Y1210143ENS0108US0
9Y1210143ENS0109US0
0.070 to 0.220 mm
0.0028 to 0.0087 in.
0.3 mm
0.0118 in.
0.070 to 0.320 mm
0.0028 to 0.0126 in.
0.3 mm
0.0118 in.
(B) Side Clearance of
Balancer Shaft 1
9Y1210143ENS0110US0
KiSC issued 07, 2012 A