Removing Power Steering Controller; Rops Model - wsm M6040 Workshop Manual

M6040, M7040, WSM

[2] REMOVING POWER STEERING CONTROLLER

(1) ROPS Model

Bonnet
1. Open the bonnet (1) and disconnect the battery negative
terminal.
2. Disconnect the connector (3) for head lights.
3. Disconnect the damper (4).
4. Remove the bonnet (1) and side cover (2) for both side.
IMPORTANT
• When disconnecting the battery cables, disconnect the
grounding cable first. When connecting, positive cable
first.
(1) Bonnet
(2) Side Cover
(3) Connector
Steering Support Under Cover and Rear Bonnet
1. Remove the steering support under cover (1).
2. Loosen the rear bonnet mounting screws (4).
3. Remove the seal (6) and panel guide mounting screw (5).
4. Disconnect the wire harness and remove the panel guide (2)
and rear bonnet (3).
(1) Steering Support Under Cover
(2) Panel Guide
(3) Rear Bonnet
7-S5
STEERING
(4) Damper
(5) Wire Harness (Head Light)
9Y1210143ENS0031US0
(4) Screw
(5) Screw
(6) Seal
9Y1210143STS0007US0
KiSC issued 07, 2012 A