Printer - Hach Anatel PAT700 User Manual

5.7 Printer

The printer icon allows you to configure the printer settings for the analyzer. You can
independently configure the printing of analysis results and the frequency of printing for
online TOC and conductivity modes.
Printer connection is made using the 9-pin D-subminiature serial port. The RS-232
interface communicates at 9600 baud, 8 data bits, 1 stop bit, no parity.
The printout report requires a 40-column printer.
• If the printer is purchased from HACH Company, the switches are preset at the
factory.
• If a Seiko Instruments DPU-414 Type II thermal printer is installed, the electronic DIP
switches must be set as listed in
DIP Switch 1
Setting
Switch
1
2
3
4
5
6
7
8
DIP Switch 2
Setting
Switch
1
2
3
4
5
6
7
8
DIP Switch 3
Setting
Switch
1
2
3
4
5
6
7
8
Table 13:
Table 13 Printer DIP switch settings
Function
Off Serial input
On High print speed
On Auto loading enabled
Off Auto linefeed disabled
On Enabled setting
Off Print density
On Print density
On Print density
Function
On 40-column printing
On Backup font enabled
On Normal characters
Off Zero = Slash
On International character set = USA
On International character set = USA
On International character set = USA
Off International character set = USA
Function
On 8 data bits
Off Parity setting = Yes
On Parity condition = Odd
Off Flow control (X on/X off)
Off 9600 baud rate
On 9600 baud rate
On 9600 baud rate
On 9600 baud rate
Setup
Page 67