Toc Tab - Hach Anatel PAT700 User Manual

Setup

5.7.1 TOC tab

Page 68
To change the printer settings:
1. Turn the printer power switch OFF.
2. Restore power while pressing the ONLINE button. Release the button when a
printout of the current settings begins.
3. Push the ONLINE button again. "DIP SW1" is printed, prompting you for changes to
switches 1 through 8.
4. Enter the settings for DIP switch 1 by pressing ONLINE for ON (enabled) and FEED
for OFF (disabled) for switches 1 through 8 in succession. The ONLINE LED
illuminates to indicate an ON entry; the OFFLINE LED indicates an OFF entry. Make
sure to enter a setting for all eight switches. The setup mode cannot be cancelled
once initiated.
5. After all eight switches have been set, a printout prompts you whether to continue or
repeat the procedure for DIP switches 1 through 3 or write the current settings to
memory. After the settings have been saved, a printout is generated and the printer
returns to normal operation. Do not turn the printer off while it is saving settings. Wait
until "Dip SW setting complete!" is printed before shutting off power.
Disabled, continuous, and percent change radio buttons determine how often an
online TOC reading will be printed. You may select disabled, continuous, or percent
change.
• Selecting disabled disables printing of online TOC readings.
• Selecting continuous (default) causes a TOC printout to occur at the end of each
analysis cycle and disables the percent change text box.
• Selecting percent change causes a TOC printout to occur only when the change in
online TOC readings between successive analyses exceeds the value specified in the
percent change box and enables the percent change text box.
Limit text box allows you to enter the percentage change in online TOC readings that
must occur between successive analyses before a printout occurs. You may select a
value from 1 to 100%. The default value is 1.
Return icon returns you to the setup dialog box and saves the changes. Any changes
are noted in the audit trail.
Figure 44 Printer dialog box, TOC tab