Analogs - Hach Anatel PAT700 User Manual

Setup

5.6 Analogs

Page 66
The analogs icon allows you to configure the analog outputs for the system. The analyzer
has analog outputs for TOC, conductivity, and temperature.
Figure 43 Analog outputs setup dialog box
TOC zero scale text box sets the TOC reading that corresponds to the lowest output for
the selected range. You may enter a value from 0 (default) to 1999 ppb. The full scale
value must be higher than the zero scale value.
TOC full scale text box sets the TOC reading that corresponds to the highest output for
the selected range. You may enter a value from 1 to 2000 ppb (default). The full scale
value must be higher than the zero scale value.
Conductivity zero scale text box sets the conductivity reading that corresponds to the
lowest output for the selected range. You may enter a value from 0 (default) to 19 µS/cm.
The full scale value must be higher than the zero scale value.
Conductivity full scale text box sets the conductivity reading that corresponds to the
highest output for the selected range. You may enter a value from 1 to 20 µS/cm
(default). The full scale value must be higher than the zero scale value.
Temperature zero scale text box sets the temperature reading that corresponds to the
lowest output for the selected range. You may enter a value from 0 (default) to 99 °C.
The full scale value must be higher than the zero scale value.
Temperature full scale text box sets the temperature reading that corresponds to the
highest output for the selected range. You may enter a value from 1 to 100 °C (default).
The full scale value must be higher than the zero scale value.
On error, return drop down list box determines the output that the analyzer produces
when an alarm condition occurs. You may select 2 mA output (default), last output, or 22
mA output.
Return icon returns you to the setup dialog box and saves any changes. Any changes
are noted in the audit trail.