Error Alarms - Hach Anatel PAT700 User Manual

Alarms

7.4.1 Error alarms

Code Message
108 UnableToReadSettings
109 UnableToWritetoSettings
112 UnableToStartPrinterModule
113 UnableToStartRS232Module
115 UnableToStartLamp
116 UnableToReadDataLog
117 UnableToWriteToDataLog
123 UnableToReadAlarmLog
124 UnableToWritetoAlarmLog
128 UvLampMonitorFailed
140 UnableToWriteAuditTrailEntry
161 TocAlarm
162 ConductivityAlarm
163 UnableToStopCurrentOperation
164 UnknownError
167 WatchDogIOCard
168 WatchDogTocAlgoithm
169 WatchDogPrinter
170 WatchDogRs232
171 WatchDogModbus
177 Exception
Page 120
Errors occur any time one of the non-critical subsystems fail or a failure occurs from
which the analyzer attempts to recover. The animation area flashes red to indicate an
error condition is present. When an error condition is present, the analyzer attempts to
recover and continue operating. See
Table 14 Error alarm messages
Table 14.
Alarm condition
Some or all of the settings could not be read from the settings file.
Analyzer cannot write to settings file.
Analyzer cannot start the printer module.
Analyzer cannot start the RS-232 module.
Analyzer cannot start the lamp module.
Analyzer cannot read data log.
Analyzer cannot write to data log.
Analyzer cannot read alarm log.
Analyzer cannot write to alarm log.
UV lamp monitor failed.
Analyzer cannot write audit trail entry.
TOC value has exceeded the configured TOC alarm limit.
Conductivity reading exceeds the USP <645> conductivity limits.
Analyzer cannot stop its current operation.
Analyzer has experienced an unknown error.
I/O Card has stopped responding.
TOC algorithm has stopped responding.
Printer has stopped responding.
RS-232 module has stopped responding.
Modbus module has stopped responding.
An exception was thrown.