Bottle Mode
6.4 Run standards
The run standards dialog box allows you to select a standards test to run. See
Figure
68.
Figure 68 Run standards dialog box
TOC calibration button takes you to the TOC calibration setup dialog box.
Conductivity calibration button takes you to the conductivity calibration load bottles
dialog box. See
Conductivity calibration, page
98.
TOC validation button takes you to the TOC validation setup dialog box. See
TOC
validation, page
102.
System suitability button takes you to the system suitability load bottles dialog box.
See
System suitability test, page
104.
Return icon returns you to the bottle mode dialog box. See
Bottle mode dialog box,
page
88.
Note: Immediately following each test the standards bottles are backflushed and allowed to
equilibrate to ambient pressure. DO NOT ATTEMPT TO REMOVE THE BOTTLES UNTIL THE
BACKFLUSH AND PRESSURE EQUALIZATION IS COMPLETE.
Page 89