Printer; Install Ferrite On The Printer Cable - Hach ORBISPHERE 410 User Manual

9.5 Printer

This menu provides the facility to print a number of reports directly to a printer. The printer must
be connected to the instrument through the instrument USB-A port.
The following information is available for printing:
Calibration reports
•
User action log files
•
Instrument configuration details
•
Measurements stored in the instrument memory
•
Cyclic measurements for continuous printing
•
Configuration
Printer configuration
Report configuration
Send files
Choose the report (or All) to print the reports that match the configuration criteria. A status bar
at the top of the screen shows printing progress.
Push the Cancel button to cancel a print job.

9.5.1 Install ferrite on the printer cable

Refer to the following steps for the ferrite installation on the USB printer cable included with the
LQV161.xx.20000 printer:
Currently only the USB port is a valid printer connection.
Calibration - Choose the channel(s) for which calibration reports are
required. Choose to print the last report or all reports for the selected
channel(s).
User actions - Define the date and time criteria for which user action logs
are required.
Configuration - Choose the channel(s) for which instrument configuration
details are required.
Measurements - Choose the channel(s) for which measurement reports are
required. Define the start and end times for the measurement reports.
Cyclic measurements - Check the enable continuous mode checkbox and
choose the channel(s) for which cyclic measurements are required.
Cancel - Exit the configuration option.
Communication Menu
77