Section 13 Specifications - Hach Anatel PAT700 User Manual

Section 13 Specifications

Operating range
Conductivity Range for TOC
Display resolution
Accuracy
Repeatability
Limit of detection
Conductivity range
Conductivity display resolution
Conductivity accuracy
Resistivity range
Resistivity display resolution
Available resistivity modes
Ambient operating range
Display resolution
Measurement accuracy
Sample water range
UV lamps
Interface/display
Maximum altitude
User I/O wiring
Standards system
Dimensions
Weight
Sample inlet flow rate range
Sample inlet pressure range
Electronics enclosure rating
Humidity rating
CE compliance
Safety rating
Protection and overvoltage
Pollution degree
Power input
PAT700 specifications are subject to change without notice.
TOC specifications
0.5 to 2,000 ppb as carbon
0.2 µS/cm for all waters, 1.0 µS/cm for all neutral waters, 5 µS/cm for water with
CO as the sole conductive species.
2
0.1 ppb
±1 ppb or 5%, whichever is greater
±0.3 ppb or ±1%, whichever is greater
0.5 ppb
Conductivity and resistivity specifications
0.05 to 150 µS/cm (@ 25 °C)
0.01 µS/cm
±1% over full range (uncompensated)
Ω
0.2 to 18 M
0.01 over full range
Temperature compensated to 25 °C, or uncompensated
Temperature specifications
10 to 40° C (50 to 104 °F)
0.1 over full range
±0.4°C
5 to 95 °C (41 to 203 °F)
Physical specifications
Two, with UV Detect technology
Color touch screen
4,000 m (13,125 ft)
Three 3/4-inch conduit openings or quick disconnect fittings
Onboard, automated standards introduction system (OASIS)
59.7 cm wide x 22.9 cm deep x 25.4 cm high
(23.5" wide x 9" deep x 10" high)
13.6 kg (30 lbs)
60 mL/min to 300 mL/min
10 to 100 psi
IP56 conduit version
IP46 quick connect version
5 to 95%
EN61010-1 and EN 61326
ETL, conforming to UL 61010-1 and CSA 22.2 No. 61010-1
Category II
2, IEC 61010-1
100 to 230 ±10% VAC, 65 W, 50/60 Hz
-cm (@25 °C)
Page 177