Selecting The Number Of Trap Managers - Paradyne 3160 Operator's Manual

Selecting the Number of Trap Managers

"
3160-A2-GB21-80
7. Press F2 (Enab) to enable trap messages over the SNMP management link.
SNMP Trap:
Next Enab
F1
If you intend to issue traps to an SNMP manager(s) from this device, you must
specify the number of SNMP managers that are to receive the traps.
Procedure
To specify the number of SNMP managers to receive traps from this device:
1. From the top-level menu screen, select Cnfig.
2. Select the configuration option set to be copied into the Edit area by using the
appropriate Function key. Use the scroll keys, if necessary.
3. Select Edit.
4. From the Edit screen, press the
the screen.
5. Select Mgmt.
Edit:
User Alarm Mgmt
F1
6. From the Mgmt Config screen, select Trap.
Mgmt Config:
Gen Trap
F1
7. Select the number of SNMP managers to receive traps (from 1 through 6) by
using the appropriate Function key. Use the scroll keys, if necessary.
Num Trap Mgrs:1
Next 1
F1
March 1999
Disab
F2 F3
key until the Mgmt selection appears on
F3
F2
F3
F2
2
F2 F3
Operation
3-27