Initiating A Call For Pc, Ascii Terminal/Printer, Or Snmp Operation - Paradyne 3160 Operator's Manual

Initiating a Call for PC, ASCII Terminal/Printer, or SNMP Operation

"
3160-A2-GB21-80
Use the Dial command to set up a semipermanent connection to route alarm
messages to the specified destination. The Dial command initiates a call through
the integral modem to a printer, ASCII terminal, or PC.
Procedure
To initiate a call at the local DSU/CSU:
1. From the top-level menu screen, press the
appears on the screen.
2. Select Ctrl.
3. From the Control screen, select Call.
Control:
Call Rel
F1
4. From the Call Setup screen, select Dial. This selection is not available if the
DSU/CSU's integral modem is already in use.
Call Setup:
Pass Dial
F1
5. From the Dial Directory screen, press F1 (Up) to display the next higher
numbered directory or press F2 (Down) to select the next lower numbered
directory.
Dial n : xxxxxxxxx
Up Down
F1
6. When the number of the desired directory appears on the screen, press F3
(Dial) to place the call.
Dial n : xxxxxxxxx
Up Down
F1
March 1999
LED
F3
F2
ChDir
F2 F3
Dial
F2 F3
Dial
F2 F3
Operation
key until the Ctrl selection
3-59