Paradyne 3160 Operator's Manual page 219

3160-A2-GB21-80
Interface Group – "ifSpeed" Object (ifEntry 5)
This object provides the interface's current bandwidth in bits per second. The
value of this object for each interface is specified as follows:
T1 Interfaces: 1,544,000 bps.
COM, AUX, The currently configured data rate for the port.
and MODEM:
Data Ports: The currently configured data rate for the port when the port is
allocated to one of the T1 interfaces. If the port is not allocated
the data rate is defined as zero.
Interface Group – "ifAdminStatus" Object (ifEntry 7)
This object specifies the desired state (configuration) of the interface. This object
is supported only for the COM and MODEM ports. It provides the ability to switch
between using the port for SNMP or ASCII operations (dial-out, front panel
emulation). The value of this object will not affect the state of any of the interfaces
on the DSU/CSU other than the COM or MODEM port. Only the following values
are supported by the DSU/CSU:
H
up(1) – The SNMP management link is active on the COM or MODEM port.
H
testing(3) – The SNMP management link is inactive on the COM or MODEM
port. These ports can be used for proprietary ASCII functions.
March 1999
SNMP MIB Objects
E-7