Starting a DTE Loopback
"
3160-A2-GB21-80
The DTE Loopback command (DLB) loops the received signal on the DTE
Drop/Insert (DSX-1) port back to the DTE without change.
DSU
DTE
DLB
ALL 1s
(DSX-1)
PORT 2
PORT 1
Procedure
To perform a DTE loopback:
1. From the top-level menu screen, select Test.
2. From the Test screen, select Lpbk.
Test:
Rlpbk Lpbk
F1
3. From the Loopback screen, press the
appears on the screen.
4. Select DLB.
Loopback:
LLB
PLB
F1
Test Started appears on Line 2. If a DTE loopback is already in progress,
the Already Active message appears. If an invalid combination of
loopbacks is in progress, the error message Invld Test Combo appears
(see
Table 4-8
for valid loopback test combinations).
March 1999
CSU
NETWORK
INTERFACE
496-14317-02
Ptrns
F2
F3
key until the DLB selection
DLB
F2
F3
Maintenance
4-25