Paradyne 3160 Operator's Manual page 80

Operation
3-46
The clock source configuration options enable you to select either the network
interface, a synchronous data port, the internal clock, the DTE Drop/Insert
(DSX-1) interface, or an external clock. If external clocking is selected, you must
use the clock rate configuration option to specify the clock rate.
shows some common clocking configurations. Two sample procedures for
configuring timing are given in the following sections,
Timing and Configuring for External Timing
configuration options, refer to Appendix C,
NOTE:
The external clock source is only available for 2-port and 4-port DSU/CSUs.
For carrier-mounted DSU/CSUs, the external clock provides timing for up to
eight slots in the carrier. Each Auxiliary Backplane must have its own external
clock input.
CLOCK: NETWORK
CLOCK: INTERNAL
CLOCK: EXTERNAL
PBX
CLOCK: DTE (G.703) CONNECTOR
TERMINAL
EQUIPMENT
CLOCK: PORT 1, 2, 3, OR 4
Figure 3-12. Common Clocking Configurations
March 1999
Figure 3-12
Configuring for Network
. For more information on
Configuration Options .
NETWORK
CLOCK: NETWORK
CLOCK: NETWORK
CLOCK: NETWORK
CLOCK: NETWORK
CLOCK: NETWORK
496-14341-03
3160-A2-GB21-80