Selecting The Number Of Trap Managers; Configuring A Destination For Snmp Traps - Paradyne 3172 Operator's Manual

Selecting the Number of Trap Managers

If you intend to issue traps to an SNMP manager(s)
from this device, you must specify the number of SNMP
managers that are to receive the traps.
To specify the number of SNMP managers to receive
traps from this device,
1. Press F3 to select Cnfig from the top-level menu
screen.
2. Select the configuration option set to be copied
into the Edit area by using the appropriate
Function key. Use the scroll keys, if necessary.
3. Press F1 to select Edit.
4. Press the key from the Edit screen to display
the SNMP selection.
5. Select SNMP.
Edit:
User
F1
6. Select Trap from the SNMP Config screen.
SNMP Config:
Gen
F1
7. Select the number of SNMP managers to receive
traps (from 1 through 6) by using the appropriate
Function key. Use the scroll keys, if necessary.
Num Trap Mgrs:1
Next
F1
3170-A2-GB20-10
Alarm SNMP
F2 F3
Trap
F2 F3
1 2
F2 F3
March 1996

Configuring a Destination for SNMP Traps

A destination must be configured for each SNMP trap
manager specified. This configuration option is displayed
for the number of trap managers specified by the Number
of Trap Managers configuration option.
To configure an IP address for the SNMP trap
manager,
1. Press F3 to select Cnfig from the top-level menu
screen.
2. Select the configuration option set to be copied
into the Edit area by using the appropriate
Function key. Use the scroll keys, if necessary.
3. Press F1 to select Edit.
4. Press the key from the Edit screen to display
the SNMP selection.
5. Select SNMP. (For screen displays, see the
previous section, Selecting the Number of Trap
Managers.)
6. Select Trap from the SNMP Config screen.
7. Press F1 (Next) until the Trapn IP Address
configuration option appears.
8. Press F2 (Edit) to edit the IP address. You have the
option of using F3 (Clear) to reset the IP address
to the factory default 000.000.000.000. Refer to
the Setting the IP Address section on page 3-15 for
more information on setting an IP address.
9. Press F1 (Next) until the Trapn Destination
configuration appears, and select the destination
for the SNMP trap by using the appropriate
Function key. Use the scroll keys, if necessary.
Trap n Dst:
Next
F1
Operation
None Com
F3
F2
3-19