Paradyne 3160 Operator's Manual page 41

3160-A2-GB21-80
Table 3-2. Network Interface LEDs (2 of 2)
Name Color Meaning
ALRM Yellow Indicates whether an alarm condition exists on the received
network signal.
ON :
OFF :
EER Yellow Indicates the Excessive Error Rate (EER) has been exceeded
on the network interface.
ON :
OFF :
NOTE:
The DTE Drop/Insert (DSX-1) interface is only available on 2-port and 4-port
DSU/CSUs.
Table 3-3. DTE Drop/Insert (DSX-1) Interface LEDs (1 of 2)
Name Color Meaning
SIG Green Monitors the signal being received from the DTE Drop/Insert
(DSX-1) interface.
ON :
OFF :
OOF Yellow Monitors Out Of Frame (OOF) conditions on the received DTE
Drop/Insert (DSX-1) signal.
ON :
OFF :
March 1999
An alarm condition (LOS, LOF, EER, Yellow, AIS) exists
on the received network signal. Use the Device Health
and Status command to determine the alarm type.
No alarm condition exists on the network interface
signal.
NOTE: This LED is only valid when ESF framing is being
used.
The EER has been exceeded on the network interface.
The EER has not been exceeded on the network
interface.
A recoverable signal is being received from the DTE
Drop/Insert (DSX-1) interface.
The signal cannot be recovered from the DTE
Drop/Insert (DSX-1) interface (a Loss of Signal
condition exists).
At least one OOF was detected on the signal during the
sampling period.
No OOFs were detected on the signal during the
sampling period.
Operation
3-7