Return Loss Meters - Agilent Technologies 8163A User Manual

Return Loss Meters

error message
description
error value
action
error message
description
test value
action
error message
description
test value
action
error message
description
test value
action
error message
description
test value
action
Agilent 8163A/B, 8164A/B, and 8166A/B User's Guide, Fourth Edition
TCFS Shutter Selftest Failed (error value)
This test verifies the shutter driver by applying a designated test pattern
25060 TCFS shutter driver electronic fails
Please return the unit to your local service center for repair
Return Loss Meters
E10010: Invalid Caldata
The Caldata loaded on the module is invalid. Either the caldata ver-
sion number is not compatible with the firmware or the caldata is
corrupt (checksum incorrect)
(no parameter)
Please return the unit to your local service center for repair
E10012: Dual ported RAM write/read test failed
Writing bit patterns and reading them back to/from the dual ported
ram failed
(no test value)
Please return the unit to your local service center for repair
E10013: FPGA not correctly initialized
Loading the FPGA with data failed. This indicates a defective FPGA
or an FPGA access problem
(no test value)
Please return the unit to your local service center for repair
E10014: Firmware corrupt, checksum error (a,b)
Firmware in flash has an invalid checksum. Either the image which
was programmed was corrupt or the flash memory has a failure
a is the stored checksum
b is the calculated checksum
Reload the module firmware. If the failure persists, please return the
unit to your local service center for repair
Error Messages
387