Selftests - Agilent Technologies 8163A User Manual

Tunable Laser Sources
error message
description
error value
action
error message
description
error value
action
error message
description
error value
action
error message
description
error value
action
error message
description
error value
action
Agilent 8163A/B, 8164A/B, and 8166A/B User's Guide, Fourth Edition
Initialization Error - module temperature out of range
(please wait a little bit and try again)!
Module temperature is too high
(no error value)
Doublecheck whether the fan is working and not blocked. Wait some
time and reboot the instrument. If the failure persists, please return the
unit to your local service center for repair.
Initialization Error - module temperature too high
(please wait a little bit and try again)!
Module temperature is too high
(no error value)
Doublecheck whether the fan is working and not blocked. Wait some
time and reboot the instrument. If the failure persists, please return the
unit to your local service center for repair.

Selftests

These tests are started after initialization of the instrument. This test
measures defined parameters, and tests them to limits.
Main Peltier Temp. Selftest Failed (error value)
Verifies whether the peltier temperature of the laser diode is within a given
range
13010 Peltier temperature is not in target range
Please return the unit to your local service center for repair
Main Thermo Temp. Selftest Failed (error value)
Verifies whether the temperature of the thermopositioner is within a given
range
13020 Thermopositioner is not in target temperature range
Please return the unit to your local service center for repair
Main Peltier Curr. Selftest Failed (error value)
Checks if peltier current for the laser diode peltier is below maximum
13050 Laser peltier current is above maximum value
Please return the unit to your local service center for repair
Error Messages
383