Agilent Technologies 8163A User Manual page 54

Getting Started
54
1 Press [Edit]. The first digit before the decimal point will be
highlighted first, as shown in Figure 23.
Figure 23 The First Digit Before the Decimal Point is Highlighted First
2 If you want to select another digit to edit, use the left or right cursor
key.
3 Enter the new value for the digit by using the numerical keypad, the
up and down cursors or turning the modify knob.
4 Repeat steps 2 and 3 to continue editing the value.
5 When you have finished editing the value, press Enter. The edited
value becomes the new value of the parameter.
To change the wavelength from 1540.000 nm to 1525.000 nm:
1 Move to the wavelength parameter for a Tunable Laser module and
press [Edit]. The most significant digit is highlighted.
2 Press the left cursor once to highlight the digit four.
3 Press the down cursor twice to change the value of the digit to two.
4 Press the right cursor once to move the cursor one digit right.
5 Press the up cursor five times to change the value of the digit to five.
Press Enter to end the editing.
Agilent 8163A/B, 8164A/B, and 8166A/B User's Guide, Fourth Edition
How to Change the Value of a Parameter