Agilent Technologies 8163A User Manual page 406

Error Messages
error message
description
test value
action
error message
description
test value
action
error message
description
test value
action
error message
description
406
KeySelftest() called without calling KeyInit() before
KeySelftest(): KeyDisable() failed
KeySelftest(): selftestPre() failed
KeySelftest(): key pressed during selftest or hardware problem
KeySelftest(): selftestPost() failed
KeySelftest(): KeyEnable() failed
KeySelftestExecPortF(): wrong interrupt number
KeySelftestPreTPU(): FreeTpultc() failed
KeySelftestExecTPU(): GetTpuDioState() failed
KeySelftestPostTPU(): AllocTpultc() failed
Selftest (stAll, 0) failed
Selftest problem. Possible causes:
- hardware failure
- key pressed during selftest
- calibration data or firmware incorrect
Please return the unit to your local service center for repair
InitKey(): unsupported keyLocation
KeyAck(): unsupported keyLocation
KeyEnable(): unsupported keyLocation
KeyDisable(): unsupported keyLocation
KeySelftestPre(): unsupported keyLocation
KeySelftestExec(): unsupported keyLocation
KeySelftestPost(): unsupported keyLocation
Calibtation data incorrect
Please return the unit to your local service center for repair
Preset (0) failed
Preset(): channel X, config Y failed
Preset failed, probably due to incorrect calibration data
X module channel
Y switch configuration number
Please return the unit to your local service center for repair
Error checking firmware CRC!
The firmware CRC is wrong
Agilent 8163A/B, 8164A/B, and 8166A/B User's Guide, Fourth Edition
Optical Switch modules