Selecting A Tunable Laser Module; Selecting/Deselecting Power Meters - Agilent Technologies 8163A User Manual

The PACT Application
Agilent 8163A/B, 8164A/B, and 8166A/B User's Guide, Fourth Edition
4 Move to <PACT> and press Enter. The PACT Setup Screen, as shown
in Figure 162, appears.
Figure 162 The PACT Setup Screen

Selecting a Tunable Laser Module

5 Move to the Module Selection box. As a default, the Tunable Laser
module with the lowest slot number is selected. Move to [Laser
Selection]. Press [Edit].
6 To select a Tunable Laser module, press [Edit], use the cursor key to
move to your preferred Tunable Laser module as denoted by slot
and channel numbers, see "Slot and Channel Numbers" on page 40,
and press Enter.
7 Perform steps until you have selected the required Tunable Laser
modules for your application and press Enter.
N O T E If no Tunable Laser module is selected, you cannot exit by pressing
Enter.

Selecting/Deselecting Power Meters

8 Move to the Module Selection box. As a default, all Power Meters are
selected, this means that all Power Meters will log power
measurements. Press [Edit].
Applications
249