Dfb Laser Sources - Agilent Technologies 8163A User Manual

DFB Laser Sources

Agilent 8163A/B, 8164A/B, and 8166A/B User's Guide, Fourth Edition
DFB Laser Sources
error message
description
test value
action
error message
description
test value
action
error message
description
test value
action
error message
description
test value
action
error message
description
test value
action
E10010: Invalid Caldata
The Caldata loaded on the module is invalid. Either the caldata
version number is not compatible with the firmware or the calda-
ta is corrupt (checksum incorrect)
(no test value)
Please return the unit to your local service center for repair
E10012: Dual ported RAM write/read test failed
Writing bit patterns and reading them back to/from the dual port-
ed ram failed
(no test value)
Please return the unit to your local service center for repair
E10013: FPGA not correctly initialized
Loading the FPGA with data failed. This indicates a defective
FPGA or an FPGA access problem
(no test value)
Please return the unit to your local service center for repair
E10040: 10bit ADC test failed (a, b, c)
The 10bit ADC has returned a value other than 512
a shows the ADC reading
b shows the lower limit
c shows the upper limit
Please return the unit to your local service center for repair
E10050: Board temp out of limits (a)
The board temperature is outside the allowed range
a measured board temperature
Please return the unit to your local service center for repair
Error Messages
399