Selecting/Deselecting Power Meters; Setting Power Meter Parameters - Agilent Technologies 8163A User Manual

Applications
228

Selecting/Deselecting Power Meters

3 Move to the Module Selection box. As a default, all Power Meters are
selected, this means that all Power Meters will log power
measurements. Press [Edit].
4 To deselect a Power Meter channel, move to the Power Meter as
denoted by slot and channel numbers, see "Slot and Channel
Numbers" on page 40, press [Unset].
5 To select a Power Meter channel, press [Edit], move to the Power
Meter as denoted by slot and channel numbers, see "Slot and
Channel Numbers" on page 40, press [Set].
6 Perform steps until you have selected the required Power Meters for
your application and press Enter.
N O TE
If no Power Meter channel is selected, you cannot 'exit' by pressing
Enter.

Setting Power Meter Parameters

N O TE
If you are using the Agilent 8164A/B Lightwave Multimeter, you may
set all Power meter parameters from the Logging Setup Screen, see
Figure 145.
Agilent 8163A/B, 8164A/B, and 8166A/B User's Guide, Fourth Edition
The Logging Application