Low/Reverse Clutch Housing Assembly - ATSG Chrysler 45RFE Service Manual

5
4
3
1
1. LOW/REVERSE CLUTCH HOUSING.
2. LOW/REVERSE STEEL PLATES (6 REQUIRED).
3. LOW/REVERSE FRICTION PLATES (6 REQUIRED).
4. LOW/REVERSE BACKING PLATE.
46
AKPPHELP.RU Руководство по ремонту АКПП
Technical Service Information
Figure 56
AUTOMATIC TRANSMISSION SERVICE GROUP
LOW/REVERSE CLUTCH HOUSING ASSEMBLY (Cont'd)
12. Install the low/reverse clutch pack beginning
with a steel plate and alternating with a friction
plate, until you have installed six of each, as
shown in Figure 56.
13. Install the low/reverse backing plate with the
inside bevel facing up as shown in Figure 56.
14. Install the low/reverse backing plate snap ring
as shown in Figure 56. This is a selective snap
ring to adjust clutch clearance.
15. Low/reverse clutch clearance should measure
1.14-1.91 mm (.045"-.075").
LOW ROLLER CLUTCH
"UPPER" SNAP RING
LOW ROLLER
CLUTCH ASSEMBLY
2
ONE WIDE
SPLINE
Copyright © 1999 ATSG
Figure 57