Remove The Front Panel/Drive Cage Assembly - HPE ProLiant BL460c Gen10 User Manual

Remove the front panel/drive cage assembly

Prerequisites
To remove the front panel/drive cage assembly, you need a T-15 Torx screwdriver.
Procedure
1. Power down the server blade on page 21.
2. Remove the server blade on page 22.
3. Place the server blade on a flat, level work surface.
4. Remove the access panel on page 22.
5. Do one of the following:
• Remove the storage controller or the NVMe passthrough board, if installed (Remove the storage
controller or NVMe pass-through board on page 34).
• Remove the direct connect SATA cable on page 31.
6. If installed, remove the internal USB drive. To locate the internal USB connector, see System board
components on page 13.
7. Remove the DIMM baffles on page 23.
IMPORTANT: When removing a DIMM baffle, do not remove the following options when installed
on the DIMM baffle:
• M.2 enablement option (left DIMM baffle)
• HPE Smart Storage Battery (right DIMM baffle)
8. Remove the front panel/drive cage assembly:
a. Extend the serial label pull tab from the front of the server blade.
b. Remove the two T-15 screws from the front panel/drive cage assembly.
c. Remove the component.
36 Operations