IBM TS7650G User Manual page 213

the ProtecTIER Replication Manager on the target server at the remote (destination)
site. By doing so, the Replication Manager remains available in a disaster recovery
situation.
This task might be completed at any time during the replication configuration
process. However, creation of the replication grid and verification of the replication
configuration, cannot take place until ProtecTIER Replication Manager is up and
running on the designated server.
Procedure
1. If it is not already displayed, access the ProtecTIER System menu on the
designated ProtecTIER Replication Manager server. See "Accessing the
ProtecTIER Service menu" on page 9.
2. From the main menu, select ProtecTIER Configuration (...). Type the
corresponding number and press <Enter>. The ProtecTIER Configuration
(...) menu is displayed.
----------------------------------------------------------------------
ProtecTIER Service Menu running on rasddx
ProtecTIER Configuration (...)
----------------------------------------------------------------------
1) Configure ProtecTIER node
2) Recover Configuration for a replaced server
3) Configure machine serial number for a replaced server
4) Configure RAS
5) Update Time, Date, Timezone & Timeserver(s)
6) Scan storage interconnections
7) File Systems Management (...)
8) Configure replication (...)
9) IP Network configuration (...)
10) Update Firmware (...)
11) Update the system's name
12) Validate configuration
13) Single Node - code upgrade
14) OS images Management (...)
15) Replace SAS drive
B) Back
E) Exit
----------------------------------------------------------------------
>>> Your choice?
3. Select Configure replication (...) . Type the corresponding number and
press <Enter>. The Configure replication (...) menu is displayed.
----------------------------------------------------------------------
ProtecTIER Service Menu running on rasddx
ProtecTIER Configuration (...)
Configure Replication (...)
----------------------------------------------------------------------
1) Configure/Unconfigure ProtecTIER Replication Manager on this node
2) Configure Static Routes
B) Back
E) Exit
----------------------------------------------------------------------
>>> Your choice?
4. Select Configure/Unconfigure ProtecTIER Replication Manager on this node.
Type the corresponding number and press <Enter>.
5. When the Replication Manager is currently unconfigured, do you wish to
configure it? (yes|no) prompt displays, type: yes <Enter>.
The system displays the following warning displays:
Chapter 18. ProtecTIER system recovery procedures
193