IBM TS7650G User Manual page 43

----------------------------------------------------------------------
ProtecTIER Service Menu running on rasddx
ProtecTIER Configuration (...)
----------------------------------------------------------------------
1) Configure ProtecTIER node
2) Recover Configuration for a replaced server
3) Configure machine serial number for a replaced server
4) Configure RAS
5) Update Time, Date, Timezone & Timeserver(s)
6) Scan storage interconnections
7) File Systems Management (...)
8) Configure replication (...)
9) IP Network configuration (...)
10) Update Firmware (...)
11) Update the system's name
12) Validate configuration
13) Single Node - code upgrade
14) OS images Management (...)
15) Replace SAS drive
B) Back
E) Exit
----------------------------------------------------------------------
>>> Your choice?
3. Select Configure replication (...). Type the corresponding number and press
Enter. The Configure replication (...) menu is displayed.
----------------------------------------------------------------------
ProtecTIER Service Menu running on rasddx
ProtecTIER Configuration (...)
Configure Replication (...)
----------------------------------------------------------------------
1) Configure/Unconfigure ProtecTIER Replication Manager on this node
2) Configure Static Routes
B) Back
E) Exit
----------------------------------------------------------------------
>>> Your choice?
4. Select Config/Unconfig ProtecTIER Replication Manager on this node. Type
the corresponding number and press Enter.
5. When the Replication Manager is currently unconfigured, do you wish to
configue it? (yes|no) prompt displays, type: yes and press Enter.
The warning below displays:
Warning: You should not configure Replication Manager on more than one
server in a grid, as doing so may cause conflicts within the grid. It is
recommended that you designate the Target server (Hub) as the
Replication Manager.
6. When the Are you sure you want to configure the ProtecTIER Replication
Manager on this node? (yes|no) prompt displays, type: yes and press Enter.
The status messages below, display:
Gathering information [ Done ]
The configurePTReplicationManager ended successfully message displays.
7. When the Press the ENTER key to continue... prompt displays, press Enter.
You are returned to the Configure replication (...) menu.
8. If the static routes have not been previously configured, continue to
"Configuring static routes" on page 14.
9. Type E and press Enter to exit.
Chapter 3. Configuring replication
23