Limiting The Network Interface Bandwidth - IBM TS7650G User Manual

5. Click Ok to save the changes and close the window.
What to do next
Go on to "Limiting the network interface bandwidth."

Limiting the network interface bandwidth

Complete the task in this topic to limit the bandwidth or throughput of a network
interface, such as a port, on a node that is running replication.
About this task
Note: This task should be performed only if it is important to limit each one of the
interfaces separately. If you want to limit the total throughput over the networks,
refer to "Setting the replication rate limit" on page 116 and set the physical
replication rate limit of the repository.
Procedure
1. From the Systems Management view, select a system that is being used for
2. Highlight one of the devices (e.g. eth3 or eth4) under Replication network
3. Click Limit bandwidth on the bottom-right of the Device properties window.
118
IBM TS7650G Deduplication Gateway for ProtecTIER
Table 33. Individual replication rate limits (continued)
Individual settings
Nominal throughput limit
when no backup or restore
load (MB/Sec)
Nominal throughput limit
during backup or restore
load (MB/Sec)
Nominal throughput limit
within a replication
timeframe (MB/Sec)
replication from the navigation pane. The IP network configuration is
displayed.
appearing in the IP Network configuration pane. The device properties are
displayed to the right.
The Limit network interface bandwidth window is displayed:
Default values (Incoming)
Max throughput
15% of max throughput
Unlimited
®
: User's Guide for FSI Systems
Default values (Outgoing)
Max throughput
15% of max throughput
Unlimited