Modifying User Access To The Share; Migrating From Active Directory To Workgroup Authentication - IBM TS7650G User Manual

15. Click Finish to submit the settings to the server.
What to do next
Continue with "Modifying user access to the share."

Modifying user access to the share

Migrating between authentication types can cause existing user definitions to be
inactive. As such, you can either:
v Create new shares
v Modify existing shares and activate Active Directory users
Procedure
Follow these steps to modify the properties, access and permissions of a CIFS
share:
1. From the Systems Management view, select an existing file system under the
2. On the Overview tab, click on the defined share you want to modify from the
3. Click on Users in the navigation pane to display the User permissions.
4. Click on the Allow checkbox to activate or deactivate user access to the shared
5. Assign the user permissions by selecting Write-enabled or Read only from the
6. Click Submit to save your modifications to the CIFS share.
Results
Once the file system view is refreshed, the Active Directory users are displayed.
The procedure is now complete.
What to do next
If you want to change the authentication type from Active Directory to Workgroup,
go on to "Migrating from Active Directory to Workgroup authentication."

Migrating from Active Directory to Workgroup authentication

The following task explains how to migrate from Active Directory authentication to
Workgroup authentication
Procedure
88
IBM TS7650G Deduplication Gateway for ProtecTIER
For further instructions, refer to "Creating a CIFS share on ProtecTIER" on page
82.
Follow the procedure below:
File System category in the navigation pane. Notice that the users defined on
the share for Workgroup authentication are inactive.
CIFS Shared Paths list and click Modify share at the bottom of the CIFS
Shared Paths frame.
Note: Alternatively, select Modify share from the CIFS > Path Sharing menu.
The Modify share wizard is displayed.
path. Users with deactivated user access cannot be associated with this share.
Permissions dropdown list.
1. From the Systems Management view, select CIFS > Authentication > Set
Authentication mode. The Authentication setup wizard is displayed.
®
: User's Guide for FSI Systems