IBM TS7650G User Manual page 209

----------------------------------------------------------------------
ProtecTIER Service Menu running on rasddx
ProtecTIER Configuration (...)
----------------------------------------------------------------------
1) Configure ProtecTIER node
2) Recover Configuration for a replaced server
3) Configure machine serial number for a replaced server
4) Configure RAS
5) Update Time, Date, Timezone & Timeserver(s)
6) Scan storage interconnections
7) File Systems Management (...)
8) Configure replication (...)
9) IP Network configuration (...)
10) Update Firmware (...)
11) Update the system's name
12) Validate configuration
13) Single Node - code upgrade
14) OS images Management (...)
15) Replace SAS drive
B) Back
E) Exit
----------------------------------------------------------------------
>>> Your choice?
3. Select the Recover Configuration for a replaced server option. Type the
corresponding number and press <Enter>.
The server type and application are automatically detected where Application
is FSI_1G or FSI_10G if replacing a server in an FSI environment.
4. On a TS7650G, the following sample output is displayed:
Begin Processing Procedure
About to execute:
Operation: replace
Model: TS7650G
Application: FSI_1G
Continue? (yes|no) yes
5. Type yes to continue.
Note: When prompted to select the node to be replaced, enter the proper
node option number. This is especially important when replacing a 2-node
system when both nodes are down. Only the valid options for replacement are
displayed, i.e. if one of the nodes is running and accessible, only the option of
replacing the node that is not running is displayed. Meaning, the system will
identify the components installed, and make a determination of the model you
are trying to recover.
The following sample output is displayed:
Chapter 18. ProtecTIER system recovery procedures
189