Resetting Alarms; Printing Data - GE Sievers InnovOx Operation And Maintenance Manual

Chapter 6: Analyzer Operation
3. Press the Alarm Stream button. Buttons for each stream appear to the right.
4. Press the stream button you want to the alarm to respond to (such as the Stream 1 button or Stream 2
button).
5. Press the Alarm Level button, and then use the numeric keypad that appears to the right to set the
threshold concentration (in ppm units). Any measurement above this threshold will trigger the alarm.
N :
This threshold concentration refers to the parameter the stream is configured to measure. For
OTE
example, if Alarm 1 responds to Stream 1, and Stream 1 is configured to measure TOC, then the
Alarm Level is in the units of ppm TOC.

Resetting Alarms

You can reset an alarm while it is being output by the Analyzer.
To reset an alarm
1. Select the I/O tab.
2. Press the button for the Alarm Output that is to be reset (such as the Alarm Output button), The Alarm
Output screen appears.
3. Press the Reset button. The Analyzer resets the alarm. The alarm is still active and will be output the
next time the concentration exceeds the selected threshold value.

Printing Data

You can print data from the Analyzer directly to a USB connected printer. The InnovOx is capable of
communicating to the following list of printers:
• DeskJet 3050
• DeskJet D1341
• LaserJet Professional P1102w
• OfficeJet 6000
We do not support the use of any other printer. To install the printer, it must first be disconnected from the
InnovOx when power cycling or rebooting the Analyzer. Once the InnovOx is on, connect a USB communication
cable (not supplied with Analyzer). Select the I/O menu and select "Printer Setup" option. Select the Printer
Disabled button to change it to Printer Enabled. Select the Search button to have the InnovOx search for a
connected approved HP Printer.
GE Analytical Instruments ©2013 141 of 238 DLM 68100-06 EN Rev. A