The Menu Screen - GE Sievers InnovOx Operation And Maintenance Manual

Chapter 6: Analyzer Operation
• CS tab — When making Online measurements, select this tab to display peaks or data from the Check
Standard, if it is enabled.
• Current tab — Select this tab to see the CO
Analyzer is currently measuring.
N :
When the Analyzer is making Grab, Check Standard, or Rinse measurements, the Main screen provides
OTE
slightly different information.

The Menu Screen

The Menu screen (Figure 22) provides you with access to all Analyzer settings and configuration options. The
Menu screen displays five tabs that provide access to the main configuration areas.
Select any of the following tabs to display the available options:
• Setup — Set the Analyzer mode and specify analysis parameters. (The button for the four basic modes
of operation (Online, Check Standard, Grab, and Rinse) are described in more detail in the following
"Setting Up Measurements (The Setup Tab)" section.
• Data — Display, print and export historical data stored in RAM. (Information for using this tab is included
in "Viewing and Exporting Data" on page 133.)
• I/O — Configure the Analyzer's input and output interfaces. (Information for using this tab is included in
"Setting Up Input and Output (I/O)" on page 137.)
GE Analytical Instruments ©2013
peaks from whichever stream (or Check Standard) the
2
Figure 22: The Menu Screen
109 of 238 DLM 68100-06 EN Rev. A