Program Control - Siemens SINUMERIK 808D Milling Programming And Operating Manual

Automatic machining

5.2 Program control

5.2 Program control
Operating sequence
Softkey functions
Disables the output of setpoints to axes and spindles. The setpoint display "simulates" the traverse
movements.
It functions the same as pressing the following key:
For more information of the program test, refer to Section "Program test (Page 91)".
All traversing motions are performed with the feedrate setpoint specified via the "Dry run feed" setting
data. Instead of the programmed motion commands, the dry run feed rate is effective.
Stops processing of the program at every block in which miscellaneous function M01 is programmed.
It functions the same as pressing the following key:
Skips program blocks that are identified with a slash in front of the block number (e.g. "/N100").
Available only in the following state:
Each block is decoded separately, and a stop is performed at each block. However, for the thread
blocks without dry run feedrate, a stop is only performed at the end of the current thread block.
It functions the same as pressing the following key:
90
1. Select the desired operating area.
2. Switch to "AUTO" mode.
3. Press this softkey to open the lower-level menu for program control.
4. Press the corresponding vertical softkey to activate or deactivate the
desired program control option (see table below for detailed softkey
functions). The softkeys selected are highlighted in blue.
Programming and Operating Manual, 12/2012, 6FC5398-4DP10-0BA0
Milling Part 1: Operation