Removing The Electrical Component Bridge Piece; Installing The Electrical Component Bridge Piece - Asko 600 Series Service Manual

ELECTRICAL COMPONENT BRIDGE PIECE
Removing the electrical component bridge
piece
1. Remove the top cover by first removing the 3
screws at the rear edge and then lifting the cover
off.
2. Remove the panel in accordance with the sec-
tion "Panel - Removing...".
3. Remove the 2 screws at the rear from the cross
member.
4. Remove the 2 screws in the front rail.
5. Remove the wiring as necessary.
6. Lift out the bridge piece.
Installing the electrical component bridge
piece
7. Lay the bridge piece in place.
8. Secure the 2 screws to the cross member and
the 2 to the front rail.
9. Reconnect the wiring.
IMPORTANT
Ensure that the wiring is correctly connected.
10. Install the panel in accordance with the sec-
tion "Panel - Installing...".
11. Fit the top cover.
IMPORTANT
Don't forget the 2 star washers for the outermost
screws of the top cover.
3
2
4
SERVICE
61