Changing The Temperature Selector; Changing The Rotary Selector - Asko 600 Series Service Manual

Changing the temperature selector (W600
and W620)
1. Remove the top cover by first removing the 3
screws along the rear edge and then lifting it
off.
2. Remove the knob by first turning it to its zero
position and then pulling it off.
NOTE
It is possible to use a polygrip (mole wrench) to
remove the knobs, but in that case remember to
put some soft material in the jaws so as not to
scratch the plastic.
3. Disconnect the terminal block.
4. Use a thin screwdriver through the hole in the
panel to release the snap fasteners.
5. Move the selector to the side and take it out.
6. Install a new selector and reconnect the ter-
minal block.
7. Refit the knob and install the top cover.
IMPORTANT
Don't forget the 2 star washers for the outermost
screws.
Changing the rotary selector (W600 and
W620)
1. Remove the top cover by first removing the 3
screws along the rear edge and then lifting it
off.
2. Remove the knob by first turning it to its zero
position and then pulling it off.
NOTE
It is possible to use a polygrip (mole wrench) to
remove the knobs, but in that case remember to
put some soft material in the jaws so as not to
scratch the plastic.
3. Disconnect the terminal block.
4. Use a thin screwdriver through the hole in the
panel to release the snap fasteners.
5. Move the selector to the side and take it out.
6. Install a new selector and reconnect the ter-
minal block.
7. Refit the knob and install the top cover.
IMPORTANT
Don't forget the 2 star washers for the outermost
screws.
2,4
5
2,4
SERVICE
5
4
4
29