Table of Contents
Advertisement
Electrical installation
the washer can only be used with an Asko Dryer. If the
washer is used seperately or with another dryer, it must be on
its own separate 220 V single phase circuit.
If the machine is to be used in a wet area, the supply must be
protected by a residual current device.
_ Connection to a permanently wired supply point must be
made only by a qualified electrician.
GROUNDING INSTRUCTIONS
Do not modify the plug provided with the appliance - if it will not fit the outlet, have a proper outlet installed
by a qualified electrician.
Water supply connection
The water supply connections must be made by
a person having the necessary competence.
Water pressure must be in the range
15—146 PSI.
A tap must be fitted in the supply pipe for the
hose.
Cold water supply
lf a new supply pipe has been installed for the
machine, it should be flushed through thoroughly
in order to remove any particles of dirt which
might otherwise block the strainer in the water
inlet of the machine.
15 3/4"-35 1/2"
Drain outlet connection
The machine is supplied with the outlet hose
ready fitted. The hose should be hung over a
suitable sink edge or drain pipe at a height of
15 3/4"—35 1/2" above the floor: the lower
height is preferable. Make sure that the hose
is not kinked.
NB! If the hose is extended, the internal
diameter of the coupling must not be less
than 1/2".
11
Advertisement
Table of Contents
