Drum Installation; Nstallation Of The Bearing And The V-Ring Cassette; Installing The Bearing; Installation Of The V-Ring Cassette - Asko 600 Series Service Manual

SPECIAL TOOLS
SPECIAL TOOLS

DRUM INSTALLATION

Part no.: 88 011 52
This tool is used for centring and is fastened to
the drum edge when removing and installing the
front end plate.
The hook is fitted between the holder and the
bottom to facilitate removal and installation of
the front end plate.
NSTALLATION OF THE BEARING AND THE V-
RING CASSETTE
Part no.: 88 011 53

Installing the bearing

The inner bearing is fitted to the tool, which is
then put into the bearing housing.
The bolt is then loaded with the outer bearing,
washer and nut, which are put on to the bolt be-
hind the bearing housing.

Installation of the v-ring cassette

The tool is first put into the bearing housing from
the rear of the machine. Then the white side of
the v-ring cassette is placed facing the flat side of
the washer, and they are put on the tool, inside
the holder. The v-ring cassette is then forced into
place by putting the nut on to the bolt and tight-
ening it.
23