Front End Plate And Inner Cover Plate; Removing The Front End Plate And Inner Cover Plate; Installing The Front End Plate And Inner Cover Plate - Asko 600 Series Service Manual

SERVICE

FRONT END PLATE AND INNER COVER PLATE

Removing the front end plate and inner
cover plate
1. Remove the protection and catch in accordan-
ce with the section "Catch - Removing...".
2. Fit the special centring tool (part no. 88 011
52).
3. Unhook the rear balancing spring from the
top side of the holder.
4. Install the hook at the bottom, between the
cradle and the bottom panel. First put the
small hook in the cradle and then push the
holder down to hook the other end in the
bottom.
5. Undo the tensioning ring and remove it.
IMPORTANT
Do not lever the tensioning ring off. Undo one
end and turn it round the holder to remove it.
6. Lift off the front end plate.
NOTE
If the end plate is stuck, a screwdriver can be used
to lever the front end plate away from the inner
cover plate.
7. Remove the special tool.
8. Remove the inner cover plate.
NOTE
If the inner cover plate is stuck, a screwdriver can
be used to lever it away from the drum holder.
Take care not to damage the rubber strip.
Installing the front end plate and inner cover
plate
9. Start by installing the inner cover plate and
special tool (part no. 88 011 52).
IMPORTANT
It is important for the cover plate to be positio-
ned with the marking UP in line with the centre
bulge on the holder.
48
3
2
5
4
9